Honeywell Vocollect, Справочник по аппаратуре

Страница: 120 / 316

| Talkman T5 Series | 120
5. Insert the exposed copper into the fuseholders and crimp into the positive and negative wires using an approved
tool.
6.
Connect the green wire to the vehicle's ground.
7. Connect the fused white wire to the vehicle’s positive power source using an appropriate connector. This may
need to be crimped onto the wire.
8.
Connect the fused black wire to the vehicle’s negative power source using an appropriate connector. This may
need to be crimped onto the wire.
9. Attach the power supply as shown in the following diagram.
Figure 75: Attach the Power Supply
10.
Secure the wires with cable ties.
Removal of an A500/T5 VMT Device from Vehicle
Talkman A500/T5 VMT components are designed for easy removal for occasional vehicle service, maintenance or
flexible operational needs.
CAUTION: Honeywell does not recommend removing the cables (CM-710-102) from the battery adapter
except when required for occasional service (i.e. once per month at maximum). Excessive removal of these
cables may damage the adapter and cable. This type of use is not covered under warranty or service plans as it
is unintended product use that is specifically not recommended.
1. Release the battery adapter from the device.
2.
Dock the battery adapter in the side of the VMT holder.
This leaves the device free to be removed and the battery adapter and cable docked and protected.
CAUTION: The battery adapter should remain cabled and docked when not in use to prevent cable
damage or accidental contact of the adapter contacts with metal surfaces.