Honeywell Vocollect, Справочник по аппаратуре

Страница: 221 / 316

| Chargers | 221
mounting a single charger, but customers may choose to purchase rails from other suppliers as long as the rails meet
Honeywell specifications. Consider the following before wall mounting your charger.
• Customer assembly required for the rail wall mount.
• Customer assumes all responsibility for the installation of charger units.
• Installer must verify that the installation meets all local building codes.
• Avoid potential hazards (electrical wires, waterlines, and similar building components) when drilling into the wall.
• Avoid blocking power outlets and other wall receptacles when installing the rail and charger.
• Anchoring a wall mount rail to a wall stud generally results in a more stable installation. If you drill into a wall
stud, do not use a screw anchor in that hole.
• If you are mounting two chargers side by side, you must leave at least 1 in. (2.54 cm.) of space between the two
units to allow clearance for the locking arms.
• Rails must be anchored to the wall at least 12 in. (30.5 cm.) from the floor to allow for proper attachment, seating,
and removal of the charger unit.
• If you are mounting a charger directly above another charger, Honeywell recommends clearance of at least 10 in.
(25.4 cm.) between DIN rails.
Figure 152: A700 charger - back view
Part Number in Diagram Description
1 power supply
2 rubber stop for leveling charger against wall
3 locking arm for securing charger to DIN rail
4 mounting hook for hanging charger on DIN rail
5 USB port for charger software upgrades (only on battery
charger)
Mounting the A700 Device or Battery Charger
You will need:
• DIN rail, slotted steel 35 mm X 15 mm, Honeywell Part #CM-1000-20-101 or customer-supplied DIN rail
meeting the following specifications