Honeywell Vocollect, Справочник по аппаратуре

Страница: 207 / 316

| Honeywell Wireless Headsets | 207
Icon Status
A wireless headset is not paired to the device
The device is searching for a headset
The device is paired with a headset but not yet connected
The device is connected to the headset
Pairing an SRX2 Headset
The
SRX2 Wireless Headset
makes pairing and connecting even easier:
• It automatically enters low power pairing mode when it is turned on.
• It can break and re-enter pairing modes from a powered-on state.
• No headset reboot is necessary.
• It accepts connections from any device that was previously paired to it.
Pairing an SRX2 Headset with an A700 Device Using TouchConnect
™
The A700 device can use TouchConnect to connect to an SRX2 Wireless Headset when:
• the A700 device is running VoiceCatalyst
• Bluetooth is enabled
• the device is sleeping (not running a task)
• a wired headset is not attached or a wireless headset is not actively connected to the device
• the parameter SRXHeadsetEnable is set to 1 (Enabled), the default
• the parameter
SrxAutoPairEnable is set to 0 (Disabled), the default
For best performance when using an SRX2 headset with a Talkman A700 device, use the latest SRX2 software
version. Obtain the latest headset software from your Honeywell portal or reseller and use the Honeywell Accessory
Update Utility to upgrade your SRX2 headset.
Note: Data sent through near field communication (NFC) is not encrypted nor does it follow any specific
safety protocol. This is because the transfer occurs over such a short range that it is extremely unlikely that
the data could be intercepted.
1. Turn on the SRX2 headset.
2. If the headset's LED is blinking blue, it is currently paired to a device. Clear the pairing by pressing the + and -
buttons simultaneously on the SRX2 headset.
Option Description
If you are sharing headsets at your site: You must first obtain the operator ID by reading the
headband:
1. Touch area of the SRX2 t-bar (headband) with the
symbol to center of the raised oval on the side
of the device with the symbol, until the device
state (ring) indicator blinks green. This associates
the operator's headband to the device enabling
VoiceConsole to recognize the operator.
2.
Touch the side of the A700 device that has the
symbol and the oval area of the SRX2's keypad
section together, aligning the ovals on each and
holding them together steadily, until the device state