HNC Electric SV-E3 Series, Инструкция по эксплуатации

Страница: 177 / 178

177
7. About alarms
The alarms in absolute system are shown below.
Relative to the incremental system alarm items, the absolute system adds the items of encoder error(( Err. 18)), multi-rotation
data error ((Er r. 2 0) and encoder low-voltage error(Err. 21). These alarms cannot be cleared by alarm resetting or restarting
the 24VDC control power. Restart the control power supply after encoder clearing.
Check the alarms on the [State display] screen
Table 9 Check the alarms on the [State display] screen
No. Alarm items Description
・
handling ways
18 Encoder error The encoder itself error occurs.
20 Multi-rotation data error
☆
The multi-rotation data changes sharply.
☆
Check the encoder cable wiring and PIN contact
☆
Perform FG grounding and countermeasures such as separation of power
cable and encoder cable.
21 Encoder low-voltage error
☆
The multi-rotation data changes sharply.
☆
Check if the battery voltage is too low for the absolute or battery cable loosen
For alarm details of the encoder, refer to the [Encoder] on the [Auxiliary function] screen.
Table 10 Alarm details for the encoder
No. Alarm items Description
・
handling ways
0 Speed error The multi-rotation ABS sensor conversion error occurs at backup or speed error
occurs at power ON
1 MR Low battery voltage warning
2 Multi-rotation ABS Sensor communication error, cannot get the multi-rotation data at power ON.
3 Position error The sensor error results in the different value between the 1-rotation ABS sensor
and multi-rotation ABS sensor, which unable to confirm the encoder position.
4 Low –voltage error Only for multi-rotation ABS encoder
The supply voltage is under the voltage specification described in the manual at
power OFF.