HNC Electric SV-E3 Series, Инструкция по эксплуатации, Страница: 116 / 178

116
Example) Make the following settings if the motor with the maximum torque of 3000 [0.1%] needs to set to 1000 [0.1%] at the
maximum command input voltage (
±
10V).
Table 8.5.4 Analog torque command input filter settings
Parameter No. Parameter Setting value
288.0 Analog torque command Input filter constant (Numerator) “1000”
289.0 Analog torque command Input filter constant (Denominator) “3000”
Note 2: Set the maximum torque for the motor in parameter 293.0, 295.0(Denominator). Set the expected torque limit value in
parameter 292.0, 294.0(Numerator).
Example) Make the following settings if the motor with the maximum torque of 3000 [0.1%] needs to set to the maximum
speed limit value of 1000 [0.1%].
Table 8.5.5 Analog torque command input Torque limit value settings
Rotation direction Parameter No. Parameter Setting value
CCW 292.0 Analog torque command
CCW torque limit value(Numerator)
“1000”
293.0 Analog torque command
CCW torque limit value (Denominator)
“3000”
CW 294.0 Analog torque command
CW torque limit value (Numerator)
“1000”
295.0 Analog torque command
CW torque limit value (Denominator)
“3000”
Table 8.5.6 Parameter 302.0 settings and rotation direction of the motor (Analog torque command input)
Value of parameter 62.0 Input analog command
Positive voltage Negative voltage
0
1
[Initial value]
8.5.3 Test run (Analog torque command input)
■
Before test run
Table 8.5.7
Make sure all the wiring are connected properly before
switch on the power to the drive and motor.
To prevent electric shock, fire, malfunction and injury.
Test run after setting the basic parameters. If set the wrong basic parameters, the motor will not
run, run unsteadily or lose control, which may cause
some injury or accidents.
Confirm the operation of the motor alone first before test
run. (Remove the other connection to the mechanics.)
The unexpected movements, such as unstable action
or lose control, may cause some injury or accidents.