Hioki MR8740-50, Инструкция по эксплуатации

Страница: 76 / 238

70
Configuring Generator-Module-Specific Settings
4
Output configuration ( Method )
You can configure the output settings.
The ground potential is cross-channel and not insulated.
With the open-collector output setting
• Limit the collector-emitter voltage to 50 V.
• Output signals require a response time of about 5 µs or less to rise from 10% to 90%. (With a load capacity
of 1000 pF and a pull-up resistamce of 1 k
Ω
, values for reference purposes)
TTL  TTL-level output (amplitude: 0-5 V)
OC
Open-collector output
5
Output
Allows you to switch waveform output settings.
The instrument may momentary output a high-level signal at the times of power-on and power-off.
OFF  Does not output any waveform
ON Outputs a waveform
6
Confirmation of the setting
After finishing the setting, click
[Send setting]
.
The instrument confirms the settings and outputs a waveform.
Configuring the pattern output settings
Pattern number
Enter an pattern number.
• When no output is enabled, the instrument outputs the pattern signal registered first.
• Turning off the instrument clears pattern data sets. After turning on the instrument, re-register pattern data
set.
1
to
16