Hioki MR8740-50, Инструкция по эксплуатации

Страница: 167 / 238

161
Waveform Calculation Procedure
Calculating existing data
(Loading data)
(To load measured data from a storage device to use for
calculation)
(p. 94)
Configuring the calculation
settings
Configure the calculation settings on the [Waveform
calculation] screen.
(p. 162)
Performing calculation Choose [Execute] to execute calculations.
(To force-quit the calculation, click the stop icon.)
Displaying calculation
results
The instrument displays results on the waveform screen.
(Saving results) Save calculation results as needed.
• To save the calculation results, click the save icon.
• The instrument can makes calculations using waveforms with a length of up to 2,000,000 points.
To make a calculation using waveforms with a length longer than this points, partly save the
waveforms with a length of less than 2,000,000 points and then reload the waveforms to make
another calculation.
• Using the memory division function allows the instrument to display calculation results of the last
measured block.
• When the instrument make a calculation using waveforms during measurement, force-quiting
calculation prohibits the instrument from displaying calculation results.
• To restart the calculation, choose [Execute] in the [Waveform calculation] screen.
To specify a range for calculation
Before executing calculation, specify a calculation range with the trace cursors on the waveform
screen. Set [Area] to [A_B] or [C_D] on the [Waveform calculation] screen.
With the [A_B] setting, the instrument calculates the data between trace cursors A and B; with the
[C_D] setting, between trace cursors C and D.
Refer to “8.2 Configuring Waveform Calculation Settings” (p. 162).
To automatically save waveform calculation results after measurement
Refer to “Automatically saving waveform data” (p. 84).
8
W
aveform Calculation Function