Hioki MR8740-50, Инструкция по эксплуатации

Страница: 46 / 238

40
Converting Input Values (Scaling Function)
When using [2-Point] : Specify two input values and those after scaling.
Enter two voltage values of an inputted signal in the [Input1] and [Input2] boxes.
Enter each of two scaled value in the
[Scale1]
and
[Scale2]
boxes.
−9.9999E+29 to 9.9999E+29
The instrument converts (scales) measured values in
volts into values in the specified measurement unit.
Example:
2 points of values
in volts
Values after scaled
V
H
: Higher potential
point
A
H
: Value for the higher
potential point
V
L
: Lower potential
point
A
L
: Value for the lower potential
point
Unit: A
[A]
A
H
A
L
V
L
V
H
Scaling values using a
conversion ratio and offset value,
both of which are calculated
using two points
Values after scaled
Actual measured values
[V]
When changing the value with the [Ratio] setting, the instrument does not change the values
for V
L
or V
H
, but the values for A
L
and A
H
, all of which have been specified with [Method] set
to [2-Point] .
When using [Sensor]
• Click the [Sensor] box, and then choose a model name of a current sensor or differential probe from
the list.
• Click the [Range] box, and then choose a measurement range from the list.
Sensor Range
Model 3273-50 30 A
Model 3274 150 A
Model 3275 500 A
Model 3276 30 A
Model 3283

10 mA

, 100 mA, 1 A, 10 A, 200 A
Model 3284 20 A  , 200 A
Model 3285 200 A  , 2000 A
Model 9010-50 10 A  , 20 A, 50 A, 100 A, 200 A, 500 A
Model 9018-50 10 A  , 20 A, 50 A, 100 A, 200 A, 500 A
Model 9132-50 20 A  , 50 A, 100 A, 200 A, 500 A, 1000 A
Model 9322 –
Model 9657-10 10 A
Model 9675 10 A
CT6700, CT6701 5 A
CT6710, CT6711 500 mA, 5 A, 30 A
Setting example:
To display values measured with Model 9018-50 Clamp on Probe using the 10 A range as values in
amperes (A)
Sensor : Model 9018-50
Range : 10 A
Unit A