HBM WTX110, Руководство по эксплуатации

Страница: 206 / 436

Transport, maintenance and cleaning
204
A4774-1.0 HBM: public
WTX110
3. Uninstall the sensor connection cable on the ADM terminal. Make a basic
connection diagram if necessary.
4. Lift the ADM connection board up carefully.
5. Make certain as you do this not to touch the ADM connection board on the
top or bottom. Do not touch any components on the motherboard.
6. Carefully position a small screwdriver on the spring fastener for the battery
and carefully press the fastener back. The battery automatically pops up.
7. Remove the battery.
8. Insert the new battery. The positive pole must be pointing up and one side
of the battery must be pushed under the large spring contact.
9. The battery can simply be pressed into the socket. As soon as the fastener
locks in place the battery is correctly positioned.
10.Set the ADM connection module in slot ADM1 again. Make absolutely cer­
tain that the connection clamps are pointing in the direction of the cable
connection (bottom).
11.Make certain as well that all the pins are seated in the right slots!
12.Press the ADM into the slot and make certain that all the pins are posi­
tioned correctly and the ADM board is inserted correctly.
13.The device is ready for operation again.