HBM WTX110, Руководство по эксплуатации

Страница: 175 / 436

Calibration
WTX110
A4774-1.0 HBM: public
173
Information
The Clr key can be used to clear the value and enter a new one.
Information
To save the zero balance before calibrating the weighing range, you must exit
Setup at this point. Answer the
Save Parameters prompt with Y . Then you
can call group 2 again to resume the calibration, skipping the zero calibration.
Menu Key Function/Secondary selection
Calibrate Load? Y Calibrate weighing range
Y Calibrate range
N Continue to step Load(mV/V)
Notice: You are recommended to use as large a
calibration weight as possible.
Calibr.Weight 999999 Suggestion for calibration weight (=weighing
range)
Clear the suggested weight value and enter any
partial load value
Mount load and confirm; continue with calibration
Calibrating... Measurement of the load signal
Load: 9999999
Display the 10 times higher weight value
resolution (as a check)
Load (mV/V): 1.40000 Display the standardized signal - see Calculate
Span
Notice: The signal can be calculated in millivolts
from the displayed mV/V value by multiplying it
by the
Excitation value (5V or 10V).