Haemonetics PCS 2, Руководство пользователя

Страница: 63 / 134

Chapter 5, Installation and Configuration 5-3
Center Protocol Select
Always reinfuse saline PPP with Saline Comp.
Never reinfuse saline PPP without Saline Comp.
Sometimes reinfuse saline PPP with Saline Comp.
PPP without Saline Comp.
8. When all desired protocols are selected, press the STOP key to exit
Protocol Configuration.
9. Press the STOP key again to exit Configuration. Toggle the write
protect switch on the Processor Card when instructed, and replace the
rear panel.
10.Exit Utilities by pressing the STOP key.
Machine Settings
Note: Machine settings do not require configuration unless the RS232
port is being utilized with an external communications device.
1. Power on the PCS2 in the Utilities mode of operation by pressing and
holding the PLASMA key while switching the power on. Hold the
PLASMA key until the Utilities menu appears on the display.
2. Select Configuration on the Utilities menu by pressing the MODIFY
PROGRAM key until the arrow points to Configuration, then press
the DRAW key. Toggle the write protect switch on the Processor Card
when instructed. (Remove rear access panel.)
3. Press the MODIFY PROGRAM key until the arrow points to
Machine.
4. Select Machine by pressing the DRAW key.
5. Set the RS232 Board Type by using the YES and NO keys. The
machine defaults to “Standard.” Leave the setting at Standard unless
further instructed. Press the MODIFY PROGRAM key after the
RS232 Board has been selected.
6. Set the RS232 Device by using the YES and NO keys. The setting
options are: Network, Disk Drive or Printer. This setting does not
require configuration unless one of the three configurable external
devices are being utilized. Press the MODIFY PROGRAM key after
the RS232 Device has been selected.
7. Set the RS232 Baud Rate by using the YES and NO keys. This Baud
Rate defaults to 19200. This setting is dependent on the type of
RS232 Device being utilized and does not require configuration if no
external RS232 Device is being used.
8. Press the STOP key to exit Machine Settings.