H3C S5810 Series, Руководство по эксплуатации

Страница: 52 / 820

1-7
To do... Use the command... Remarks
Configure the
aggregation group to
work in dynamic
aggregation mode
link-aggregation mode dynamic
Required
By default, an aggregation group
works in static aggregation
mode.
Exit to system view quit —
Enter Ethernet interface
view interface interface-type
interface-number
Assign the Ethernet
interface to the
aggregation group
port link-aggregation group
number
Required
Repeat the two steps to assign
multiple Ethernet interfaces to
the aggregation group.
Assign the port a LACP
priority
lacp port-priority port-priority
Optional
By default, the LACP priority of a
port is 32768.
Changing the LACP priority of a
port may affect the
selected/unselected state of the
ports in the dynamic aggregation
group.
z
Removing a dynamic aggregate interface also removes the corresponding aggregation group. At
the same time, the member ports of the aggregation group, if any, leave the aggregation group.
z
To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports
aggregated at one end are also aggregated. The two ends can automatically negotiate the selected
state of the ports.
Configuring an Aggregate Interface
You can perform the following configurations for an aggregate interface:
z
Configuring the Description of an Aggregate Interface
z
Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
z
Shutting Down an Aggregate Interface
Configuring the Description of an Aggregate Interface
Follow these steps to configure the description of an aggregate interface:
To do... Use the command... Remarks
Enter system view system-view —
Enter Layer-2 aggregate
interface view interface bridge-aggregation
interface-number
—