H3C S5810 Series, Руководство по эксплуатации

Страница: 186 / 820

1-5
To do… Use the command… Remarks
Enter system view system-view ––
Enable GVRP globally gvrp
Required
Globally disabled by
default
Enter Ethernet
interface view or Layer
2 aggregate interface
view
interface interface-type
interface-number
Enter Ethernet
interface view,
Layer 2
aggregate
interface view,
or port-group
view
Enter port-group view
port-group manual
port-group-name
Required
Perform either of the
commands.
Enable GVRP on the port or port group gvrp
Required
Disabled by default
Configure the GVRP registration mode on
the port or port group gvrp registration { fixed |
forbidden | normal }
Optional
The default is normal .
z
GVRP can be configured only on trunk ports.
z
In an MSTP network, GVRP can run on only the CIST. In addition, blocked ports on the CIST
cannot receive/send GVRP packets.
z
If both GVRP and remote port mirroring are used, GVRP may register the remote probe VLAN to
unexpected ports, resulting in undesired duplicates to be received by the monitor port. For more
information about port mirroring, refer to Port Mirroring Configuration in the Access Volume.
z
Enabling GVRP on a Layer 2 aggregate interface enables both the aggregate interface and all
selected member ports in the corresponding link aggregation group to participate in dynamic VLAN
registration and deregistration.
z
On a GVRP-enabled trunk port, you need to configure the port trunk permit vlan all command on
the port to ensure that the traffic of all dynamically registered VLANs can pass through the port.
Configuring GARP Timers
Among the four GARP timers, the LeaveAll timer is configured in system view and takes effect on all
ports, while the other three are configured on a port basis.
Follow these steps to configure GARP timers:
To do… Use the command… Remarks
Enter system view system-view ––