GSK GSK928TE, Руководство пользователя

Страница: 86 / 187

GSK928TE
Ⅱ
Turning CNC System User Manual
81
Chapter 3 Commands and their Functions
Here describes the function and the specification of all commands of GSK928TE CNC System.
Ⅱ
3.1 G commands — Preparatory Function
G commands are defined as the run mode of machine, composed of the character G and the
following 2-digit as the following table. G commands of GSK928TEII CNC System are as follows:
Command Function Modal Programming format Remark
G00 Rapid traverse movement
Initial
state
G00 X(U)Z(W)
G01 Linear interpolation * G01 X(U) Z(W) F
F:5-6000 mm
/min
G02 Circular interpolation (CW) *
G02 X(U) Z(W) R F
G02 X(U) Z(W)I K F F:5-3000 mm
/min
G03 Circular interpolation (CCW) *
G03 X(U) Z(W)R F
G03 X(U) Z(W)I K F F:5-3000 mm
/min
G33 Thread cutting * G33 X(U) Z(W) P(E) I K
G32 Tapping cycle G32 Z P(E)
G90 Inner and outer surface turning cycle * G90 X(U) Z(W) R F
G92 Thread cutting cycle *
G92 X(U) Z(W) P(E) L I
K R
G94 Outer and inner face (taper) cycle * G94 X(U) Z(W) R F
G74 Deep hole machining cycle on face G74 X(U) Z(W) I K E F
G75 Grooving cycle G75 X(U) Z(W) I K E F
G71 Outer roughing cycle G71 X I K F L
G72 Face roughing cycle G72 Z I K F L
G22 Part cycle start G22 L
G80 Part cycle end G80
G50 Create workpiece absolute coordinate system G50 X Z
G26 X, Z reference point return G26
Rapid traverse
in G00
G27 X reference point return G27
Rapid traverse
in G00
G29 Z reference point return G29
Rapid traverse
in G00
G31 Skip function G31 X(U) Z(W) F
G04 Dwell G04 D
G93 System offset G93 X
（
U
）
Z
（
W
）
G98 Feed per minute * G98 F 1
～
6000 mm /min
G99 Feed per rev G99 F
0.01
～
99.99 mm
/rev
Note 1: The commands with * in above-mentioned table are the modal one which are still valid
even if the other G commands are not specified.
Note 2: Each block can have only one G command (Only G04 command can be applied with the
other G commands in one block).
Note 3: It is in G00 or G98 when the system powers on or resets.
3.1.1 G00 — Rapid Traverse Movement(Positioning)
Command format
：
G00 X
（
U
）
Z
（
W
）