GSK GSK928TE, Руководство пользователя

Страница: 77 / 187

GSK928TE
Ⅱ
Turning CNC System User Manual
72
Output 2
：
Note 1:
The corresponding bit output is valid if each bit of output interface diagnosis is 1. When
the bit is 0, the corresponding bit output is invalid.
Note 2:
The output interface diagnosis is displayed to the hold state of current each output bit. If
the signal is the pulse mode, the bit is displayed to 0 although its output is valid.
Note 3:
Press the mode selection key to enter another mode.
4.8.3 Encoder — Spindle Encoder ands Spindle Rotating Test
If P11 Bit3 is set to 1, this system can detect and display the pulse/rev of spindle encoder, and
automatically set the encoder LINE Bit of P11 according to the detection after entering
DIAGNOSIS mode as Fig. 24. The spindle speed is the current actual speed. Unit: r/min.
The encoder lines are the pulse/rev.
z P11 Bit3 determines whether the system detects and displays the encoder lines in
DIAGNOSIS mode.
z The encoder diagnosis can display the actual value when the spindle encoder is installed
and the spindle is started, otherwise the system prompts: 0000.
z The spindle encoder rotates with the spindle synchronously, i.e. the encoder also rotates
one circle when the spindle rotates one circle, otherwise the detected spindle speed is not
coincident with the actual one.
In “Manual” mode, the spindle encoder lines are detected, but LINE bit of P11 cannot be set
Signal name Output interface diagnosis
TZL Tool post CCW
TFL Tool post CW
M03 Spindle CW
M04 Spindle CCW
M05 Spindle stop
M08 Cooling ON
M09/M79 Cooling OFF
MSP Spindle brake
A01 Alarm lamp red
Signal name Output interface diagnosis
M10 Workpiece clamped
S04 No. 4 gear spindle speed
M11 Workpiece released
S03 No. 3 gear spindle speed
U02/M78 No. 2 user output
S02 No. 2 gear spindle speed
U01 No. 1 user output
S01 No. 1 gear spindle speed
A02 Alarm lamp green