Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
V
o
lume IV
V
o
lume IV
Inst
allation &
Connecti
on
Chapter One System Configuration & Installation
159
CHAPTER ONE SYSTEM CONFIGURATION & INSTALLATION
1.1 System Composition
GSK218MC CNC system is mainly composed of the following units; refer to the Fig.
1-1.
(1) GSK218MC CNC system
(2) Additional operation panel (optional parts)
(3) Digital AC servo drive unit (step drive unit)
(4) Servo motor (step motor)
(5) AC transformer
GSK218MC
CNC system
AC
transformer
Drive unit
Motor
~380V
The strong
current
cabinet of
the
machine
Fig. 1-1
1.2 System Installation and Connection
Firstly, check whether the parts, such as CNC system, the drive unit, the motor and the
photoelectric encoder, etc, to be installed are all prepared, in good condition and matched with each
other.
The installation of CNC system must be fixed, and some space should be reserved around
CNC system, so that the heat of the system can be sent out. The CNC system should be installed
not only on the convenient for operating, but also on the place where depart from the machining iron
chips and coolant.
The strong and weak currents should be separated, and the power supply of CNC system and
the drive unit should be provided by the isolation transformer, and the power supply should be
parted with the strong current of the machine. The various cables should keep far away from AC
contractor to reduce the interference. It would be best that the photoelectric encoder, the limit signal
