Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
274
Appendix
1. The above-mentioned parameters (TMR) are related with the performances, such as the type
and the rotation velocity of the tool magazine.
2. If the above-mentioned parameters (TMR) are set incorrect, the alarm may occur and the
tool-change can not be normally performed.
The ladder diagram is coincident with the configuration of the tool magazine based upon the
basis operation from A to F steps; however, the tool magazine can not be normally operated. The
tool magazine only can be positive, negative, infeed and retraction by the setting and operation on
the Section Two, so that check each step of the tool magazine is normal.
2. The manual and zero return operation of the tool magazine
Operation purpose: Check each step of the tool magazine is normal.
The detailed operation steps are shown below:
A. Tool magazine usage enabled.
1. User the Ladder01.grp ladder diagram in the system default state, that is, the cone tool
magazine ladder diagram. Bit parameter NO: 53 #0=1, NO: 53 #1=0, NO: 53 #2=0 and NO:
53 #3=0.
2. The KPAR parameter K001.0 of the PLC is set to 1.
B. Confirm the tool rotation direction:
In the manual mode, press the
button, the tool magazine rotates following with the
addition of the tool number; press the
, the tool magazine rotates following with the
decrease of the tool number; otherwise, the tool magazine counting may disorder, so that
tool-change is incorrect. Solve this problem by adjusting the tool magazine and rotating the motor’s
phase-sequence.
C. The zero return operations of the tool magazine:
The zero return operation of the tool magazine can be divided into: with zero return switch and
without the zero return switch.
1. Tool magazine with the zero return switch: Press the
in the “Mechanical zero return”,
the zero return is completed (the indicator flashes means that the tool magazine is being performed
the zero return) when “Tool magazine zero return indicator” ON.
2. When the tool magazine is without zero return switch, set the tool magazine zero point based
upon the following steps:
