GSK GSK218MC, Руководство пользователя

Страница: 292 / 336

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
276
Appendix
6) Install the tool handle without nail on the tool magazine, and the adjust it.
7) In the system MPG mode, move the Z axis up and down (Carefully operate it!). in this case,
directly revolve the motor’s rotor or connect to the spindle on the motor’s rotor, cycle it for more than
one circle, and then adjust the spindle position by hand, till the key on the spindle enters the groove
of the tool handle.
8) Set the positioning angle in the spindle drive. (Refer to the Appendix: The Setting Method of
the DAP03 Positioning Angle for details.)
B. The adjustment of the tool-change coordinate position
1. Move the spindle to the safety position in the manual mode after the orientation adjustment is
performed based upon the above-mentioned methods, then perform the spindle orientation, and then
perform the tool releasing motion; install the nail on the tool handle (in this case, the tool magazine is
still on the infeed position). Adjust the tool-change coordinate position (It is important to ensure that
the tool is already on the releasing state) by moving the Z axis up and down in the system’s MPG
method. Lastly, record the adjusted machine coordinate of the Z axis (For example: -120.000).
2. Perform the tool clamping motion, so that the tool magazine returns to the tool-retraction
position (It is important to ensure that the tool is already on the clamping system) by .
3. In the MDI mode, Set the K010.7 to 0 in terms of the above-mentioned methods.
4. The recorded Z axis machine coordinate before is set at the data parameter 0052, it is
necessary to set this parameter correctly; otherwise, the unexpected hazard may occur to cause the
machine damage.
The correct tool-change operation can be operated based upon the above-mentioned two steps.
The operation descriptions for performing the T and M codes are shown below:
TxxM6; The execution effect is same as the Txx; M6;
T0M6; The tool on the spindle will not return to the tool magazine.
Notice : When the spindle tool number is treated as 0, do not install the tool on the spindle;
otherwise, the unexpected accident may occur when tool-changing, it may be damaged
the machine, too!
Attachment: The setting method of the DAP03 positioning angle
1) Turn on the power of the controllable equipment, LED default display: ;
2) Enter the monitoring mode by , then display: ;