General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 42 / 120

Installation & Connections Shelf and Card Connections
2-14 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
Craft Port (DCE Interface)
(Interface “D” in Figure 2-1 )
The SCIP Front Panel Craft (or console) port is an RS-561-compatible 8-pin modular jack that
supports 9600bps asynchronous data. It provides terminal interface control of the unit by direct
connection to a local VT100-compatible ASCII terminal. Connection to the Craft port requires an
8-pin modular to 8-pin modular cable (GDC P/N 830-128-007 and GDC P/N 029H210-001 or
029H211-001). The table below describes the Craft port pinouts
Ethernet (LAN) Ports
(Interface “E” in Figure 2-1 )
The SCIP Front Panel LAN ports support 10/100BASE-T Ethernet connectivity. This port requires
an 8-pin modular to 8-pin modular straight-thru or crossover cable (GDC S-078H010-XXX or S-
078H011-XXX). The table below describes Ethernet port pinouts.
Note
Auto-MDIX is not supported . A crossover cable must be used at the LAN ports unless connecting to a SC-ES
or other switch device that supports Auto-MDIX.
Table 2-7 Craft Port Pinouts (DCE Interface)
Pin Signal Direction Description
1 No Connection - -
2 DCD From SCIP Data Carrier Detect - Always on
3 DTR To SCIP Data Terminal Ready - Not used
4 Signal Ground - Signal Ground
5 RXD From SCIP Receive Data - Supervisory data to the terminal
6 TXD To SCIP Transmit Data - Supervisory data from the terminal
7 CTS From SCIP Clear To Send - Always on
8 RTS To SCIP Request To Send From the terminal
Table 2-8 Ethernet LAN Port 1 & Port 2 Pinouts
Pin Signal Direction Description
1 Rx+ To SCIP Receive Data
2 Rx- To SCIP Receive Data
3 Tx+ From SCIP Transmit Data
6 Tx- From SCIP Transmit Data