General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 59 / 120

SCIP Configuration Configuring Typical SCIP Networks
076R200-000 SpectraComm IP T1 Router Card 3-13
Issue 13 Installation and Operation Manual
7. Configure the serial0 interface for PPP by typing:
configure interface link-encap serial0 ppp
8. When the Warning message appears, type Y .
9. Enter a description for the interface by typing:
configure interfaces description serial0
[your_decription]
For example:
configure interfaces description serial0 miami_central
10. Enable the interface by typing:
configure interface enable serial0
Note
Type
show interfaces
to check your interface entries. Modify, if needed.
11. Set up static routes for the PPP (leased line) network by typing:
configure ip-route add serial0
[destination IP] [destination mask]
[next hop/gateway] [metric]
Note
Steps 12 through 14 detail the setting up of static routes in an example PPP network ( Figure 3-3 ). If a local
router is used at the central site instead of a SCIP-T1 device, consult your router documentation for static
route configuration guidelines.
12. Set up a static route at a remote site towards the central site by typing:
configure ip-route add serial0 128.1.0.0 255.255.0.0 128.1.1.10 1
13. Set up a static route at a central site SCIP-T1 towards a remote “orlando_lan” 172.16.0.0 by
typing:
configure ip-route add serial0 172.16.0.0 255.255.0.0 172.16.5.6 1
As an alternative, to set up a static route only to a particular host instead of to the whole
network, set up the static route with mask 255.255.255.255. For example, to set up LAN
Device #1 on 172.16.0.0 network with an IP address of 172.16.5.10, type:
configure ip-route add serial0 172.16.5.10 255.255.255.255 172.16.5.6 1
14. Set up a static route at the central site towards the LAN Device #1 connected at the Terminal
Server port by typing:
configure ip-route add serial0 192.160.1.12 255.255.255.255 172.16.5.6 1
15. Type
show config
to display the current configuration of the SCIP-T1. This concludes
the required configurations for a PPP T1 network. Test your example network by pinging from
your PC/workstation at the central site to equipment at the remote office, and vice-versa.
Note
If your application requires the management of terminal server devices, refer to the Terminal Server
Management procedures later in this chapter.
Note
When setting up static routes, type the short-cut conf ip a ? to get a list of all required arguments.