General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 47 / 120

076R200-000 SpectraComm IP T1 Router Card 3-1
Issue 13 Installation and Operation Manual
Chapter 3:
SCIP Configuration
SCIP Configuration Overview
SCIP configuration is performed through the command line interface (CLI). You can execute
commands locally at the craft port, or remotely from a hyperterminal connection via Telnet or SSH
clients. A brief overview of CLI is provided below. Information on using the web-based CLI is
provided in
Chapter 4, The Web Interface .
The command line interface is an interactive means of configuring the SCIP through a Telnet
session over the LAN/WAN, PSTN, or by typing commands at a VT100-compatible ACSII
terminal connected to the SCIP
CRAFT
port. The CLI is a smart, controlled-access interface that
provides general and context-sensitive help, automatically expands abbreviated command or
subcommands and also anticipates any required command arguments. The CLI will prompt for any
required argument that is missing from a command line.
Smart CLI Quick Reference
• Get context-sensitive command help by using the
?
character in the CLI command string or
by referring to the commands, parameters and arguments in Appendix A, Application
Guidelines .
• Type ? at the command prompt to view a description of IP and Utility commands (shown
below). If you are in User mode, several of the commands shown below will not display.
_______________________SpectraComm IP Commands______________________
clear Reset functions
configure Configure system parameters after admin
connect Connect to terminal interface or modem
default Default configuration to factory values.
disable Turn off supervisor/admin commands
enable Turn on supervisor/admin commands
help Description of the command line interface and help system
ping Send ping to remote device
show Show system parameters
trace-rte Trace route packet takes to remote device
_______________________Utility Commands______________________________
batch Store and/or run commands in batch mode
diags
Run diagnostics
exit Exit SpectraComm IP Command Line Interface
flash Copy flash files/select flash boot file
lanx-util LANX Utilities
reboot Halt and perform a reboot
netstat
Show TCP socket connections
services Show/Enable/Disable HTTP, SNMP, SSH, TELNET, FTP, TFTP Services
who-am-i Show current user name
• Execute each command string by pressing the
Enter
key (or <
cr
>).
• Commands entered with the proper syntax and all required parameters and arguments will take
affect immediately. If required parameters or arguments are missing from the command string,
you will be prompted for them individually.
• Abbreviated commands are accepted at the command prompt.
• To configure IP and subnet mask addresses, refer to Appendix A, Application Guidelines .