General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 51 / 120

SCIP Configuration Initializing the SCIP
076R200-000 SpectraComm IP T1 Router Card 3-5
Issue 13 Installation and Operation Manual
Configuring Management
SCIP is pre-loaded with default settings for many of the required and optional management settings
described below. If the default value applies to your network, you do not need to re-enter it.
Otherwise, enter the value that best suits your network environment. Type
?
following any
command, sub-command or parameter for context-sensitive online help.
Required Settings
To configure the SCIP for management, both SCIP devices must be changed from their default
services
settings, as shown below
1. To block or permit one or more services, type the following command:
services
[interface] [
enable
or
disable
]
where the [interface] value can be:
ftp
,
tftp
,
http
,
telnet
,
snmp
,
ssh
2. To block or permit incoming management traffic through one or more interfaces, type:
services access
[
enable
or
disable
] [interface]
where the [interface] value can be: [
e0, m0, s0,
or
all
]
Optional Settings
3. Set the system prompt by typing:
configure prompt
[SCIP]
4. Configure the Inactivity Timer to disconnect a management session after the desired interval
(in seconds) has elapsed. Range is 0 - 10,000 sec, where 0 disables the timer.
configure inactivity
[900]
5. Configure SNMP with your site-specific information and enable SNMP for read-only (ro)
access by typing the following commands:
configure snmp community add
[community name]
ro en
configure snmp system name
[your system name]
configure snmp system contact
[your system contact]
configure snmp system location
[your system location]