General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 17 / 120

Introduction and Specifications SpectraComm IP Overview
076R200-000 SpectraComm IP T1 Router Card 1-5
Issue 13 Installation and Operation Manual
Management
In Router Mode, remote SCIPs can be managed from the Central Office via Remote Default Routes.
In LAN-X mode, local and remote SCIP devices can be managed and pinged from either site.
Management protocols available in SCIP are described briefly below.
Smart CLI
The SCIP employs an interactive command line interface that will feel familiar to most field
personnel. Added features include auto-prompting for command arguments, recognition of
abbreviated commands, online help, command line recall and an advanced utility for generating
downloadable ASCII configuration files.
Enhanced Telnet/SSH Management
SCIP provides enhanced Telnet or SSH “cut-thru” to up to eight LAN-attached devices via rear
panel terminal server connector. Using the SCIP management IP address, remote devices are
accessed by menu and a TCP port number (2001 - 2008 for Telnet, 3001 - 3008 for SSH) rather than
separate IP addresses for each device.
Remote Dial-Up Management
When the SCIP is equipped with an integral modem, it can be managed via a password-protected
dialup connection from the Central Office.
TFP or TFTP Services
SCIP supports File Transfer Protocol (TFP) and Trivial File Transfer Protocol (TFTP) servers for
the downloading of GDC firmware (Flash) upgrades. These services can be enabled and disabled.
Web Management
The SCIP supports direct web management via HTTP for internet-ready network monitoring. An
embedded web server agent allows Read or Read-Write access to SCIP using popular browsers. To
enhance security, SCIP supports web time-outs and password-protected access over the web
interface. HTTP services can also be disabled to block web access to SCIP devices.
SNMP Management
An embedded SNMP agent allows discovery, retrieval of statistics, alarm traps and Read access to
SCIP using any standard SNMP controller. SNMP access can be disabled to avoid hacks during
intervals of heightened security.
Note
SNMP support will not require a SpectraComm Manager (SCM) card co-located in the shelf.
TEAM Management (Future Release)
The SCIP supports auto-discovery and polling by GDC’s TEAM software. TEAM uses HPOV APIs
(Application Programmer Interfaces) to integrate with HP OpenView Windows and other network
management applications. In a future release, the SCIP will be able to launch a direct Telnet or web-
based CLI session from the map window. For more information, contact your GDC representative.
Note
TEAM support requires an SCM card at version 5.80 or greater and co-located in the shelf with the SCIP.
For more information, refer to the GDC TEAM Core documentation and Release Notes.