General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 29 / 120

076R200-000 SpectraComm IP T1 Router Card 2-1
Issue 13 Installation and Operation Manual
Chapter 2:
Installation & Connections
Overview
The SCIP card is designed for rack-mounting in a GDC SpectraComm 5000 or SpectraComm 2000
shelf. The card can also be deployed in any model of the SpectraComm standalone enclosure. This
chapter describes installing the SCIP card, making power connections, performing pre-operational
checks, and making system connections. If this is your first installation of the SCIP, be sure to read
the previous sections of this manual to understand the optimal functioning of the SCIP product as
it applies to your network.
This chapter also provide brief procedures for setting up SCIP’s internal modem (if so equipped).
An overview of CLI and detailed procedures for quickly setting up the SCIP for IP forwarding or
LAN-extension are provided in
Chapter 3, SCIP Configuration .
Note
The LAN-X mode and IP forwarding functions are mutually exclusive; that is, when the SCIP is configured
for LAN-extension mode, the IP routing functions are not available, and visa-versa.
Shelf / Enclosure Installation Guidelines
• Locate the SpectraComm shelf in a ventilated area where the ambient temperature does not
exceed environmental specifications (
Table 1-2 ).
• Do not install the shelf directly above equipment such as power supplies, which generate large
amounts of heat.
SpectraComm IP Router Card Installation Guidelines
• The SCIP card may be installed in any slot in a SpectraComm shelf or enclosure.
• Determine whether the SCIP is to function as an IP forwarding device (router) or as a LAN
extension device in your network.
• Perform the setups, connections, and pre-operation checks for IP forwarding or for LAN-X
mode, in their entirety, as described in this chapter.
• The SCIP comes from the factory with only the Modem and the AUX ports
Enabled
.
Note
IMPORTANT SECURITY PRECAUTION:
Make sure to change the default password at the Craft port before connecting the Modem port or
the AUX port to the network.