General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 58 / 120

SCIP Configuration Configuring Typical SCIP Networks
3-12 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
Static Routing with PPP over a T1 Network
In this procedure, the default value for each parameter is shown in the command string as: [default].
If the default value applies to your network, you do not need to re-enter it. Type
?
following any
command, sub-command or parameter for context-sensitive online help.
When modifying the T1 parameters in SCIPs already deployed in a network, be sure to change the
far end unit first, then configure the near end unit. Communications will be interrupted and then will
restart when the near end unit matches the new T1 values at the far end. Note that the terms “near
end unit” and “far end unit” refer to their relative location to the user.
Note
IMPORTANT! For deployed SCIPs, always change the T1 configuration of deployed SCIPs in the proper
order (i.e., far end unit before near end unit). Otherwise you will lose access to the far end device.
1. After initializing the SCIP as described earlier in this chapter, perform the following steps to
configure the unit as an IP router in a PPP (leased line) network ( Figure 3-3 ).
2. Set the system prompt by typing:
configure prompt
[your_site]
For example:
configure prompt orlando-unit
3. Configure the T1 values for your network.
configure t1 clock-source
[line]
configure t1 fdl
[ANSI-T1.403]
configure t1 framing
[ESF]
configure t1 lbo ds1
[0.0dB]
configure t1 linecode
[B8ZS]
configure t1 timeslots
[1-24 64]
Note
When configuring the Line Buildout for DSX1, SCIP uses five ranges of lengths: 0 - 133 ft, 133-266 ft,
266-399 ft, 399 - 533 ft, 533-655 ft. Be aware that if you select a value at the beginning of a range, such as
133 ft, SCIP will use the lower range that includes that value.
Note
Type show t1 to check your T1 value entries. Modify, if needed.
4. Configure the Ethernet IP address and mask by typing:
configure interfaces ip-address ethernet0
[###.###.###.###
###.###.###.###]
For example:
configure interfaces ip-address ethernet0 172.16.5.6 255.255.0.0
5. Enter a description of the Ethernet interface by typing:
configure interfaces description ethernet0
[your_description]
For example:
configure interfaces description ethernet0 orlando_lan
6. Enable the Ethernet interface by typing:
configure interfaces enable ethernet0