General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 28 / 120

Introduction and Specifications Technical Specifications
1-16 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
Note
It should be noted that the Temperature Cycling Normal Conditions Test (R5-3) was modified to run above
the normal -40 C to 60 C degrees range. Actual temperature tested is from -40 C to 75 C).
Terminal Server
Interface DTE Speeds Asynchronous 300, 1200, 2400, 9600, 19200, 38400, 57600,
115200 (RS232)
Diagnostics CLI-commanded T1 diagnostic tests for: Network Loopback, Payload Loopback, Self Test,
Self Test with loopback; CLI-commanded connectivity check for LAN-X mode.
Supported
Protocols Frame Relay LMI
(UNI-U) ITU-T Q.933 Annex A
ANSI T1.617 Annex D
Consortium LMI.
Frame Relay
IP Encapsulation RFC 1490 IETF, Cisco (raw), SNAP
Frame Relay PVCs Maximum number: 16
Point-to-Point Protocol
(PPP) RFC 1661 (1994), also known as STD 51
LAN-X GDC Proprietary LAN extension
Ethernet ANSI/IEEE 802.3;
Rates: 10 Mbps, 100 Mbps
Spanning Tree IEEE 802.1D 1998
Security and
Authentication Local Authentication
Authentication Protocol Version1.78 (CISCO)
Modem Authentication (if equipped with internal modem)
SSH Secure Shell Protocol
Compliance &
Compatibility SCIP Card in any
shelf/enclosure NEBS Level III Compliant with GR-1089-Core, GR-63-Core,
GR-78-Core
FCC Part 68 approved; FCC Part 15 approved.
UL Listed; CUL listed.
Compliance with Bell Pub. 62310 and ANSI T1.410 standards
Integral Modem FCC Part 68 approved; FCC Part 15 approved.
UL Listed; CUL listed.
Compliance with Bell Pub. 62310 and ANSI T1.410 standards
SCIP Card installed in
SC2000 shelf only Meets certain requirements of the NEBS GR-2834-CORE
document:
Severe Climatic Conditions (R5-2)
Temperature Cycling Normal Conditions (R5-3).
Table 1-2 SCIP Specifications
Item Specification Description