Diagnostics & Monitoring
Monitoring Features
076R200-000
SpectraComm IP T1 Router Card
6-7
Issue 13
Installation and Operation Manual
Monitoring Features
SNMP Traps
SCIP supports SNMP traps for several events, listed below:
All traps are queued for up to four trap hosts and are kept on the queue until IP connectivity to the
trap host is verified. The last ten traps for each trap host are queued. Queuing SNMP traps before
sending to the trap host greatly improves the trap success in the event of network outages. Once the
network is restored and IP connectivity is verified, the queued trap is sent.
shows a
typical SNMP trap program displaying traps sent by a SCIP device. Each log message is time-
stamped with a relative System Up Time (default) or with GMT, if so configured. Refer to Chapter
5 under the paragraphs on
as needed.
SNMP Trap Configuration
Configure SCIP to send SNMP alarm traps to designated IP addresses as described below.
1. Login to SCIP as an administrator or supervisor.
2. Configure the destination IP address for SNMP traps by typing:
configure snmp trap add
[destination IP address] [community]
enable
3. Identify the SCIP in SNMP format by typing:
configure snmp system
[name]
configure snmp system
[contact]
configure snmp system
[location]
4. Configure the community name and define access privileges by typing:
configure snmp community add
[community name] [access privilege]
enable
Note
Access privileges are defined as read-only (
ro
) or read-write (
rw
).
5. To show the configured SNMP trap parameters, type any of the following commands:
show snmp traps
show snmp traps community
show snmp traps system
Figure 6-8
SNMP Trap Log Showing T1 Traps
•
Cold start
•
Authentication failure
•
Ethernet0 LinkUp/Down
•
Serial0 LinkUp/Down
•
Serial1 LinkUp/Down
•
Modem0 LinkUp/Down (if equipped)
•
Etherswitch port1 Up/Down
•
Etherswitch port2 Up/Down
•
Contact sense Started/Stopped
•
Contact alarm Active/Clear
•
MACL violation
04/30/2009 | 08:58:07 | 172.16.10.201 | (G) Link Up - - scipt1
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Cold Start - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Up ethernet0 - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Down - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Down serial0 - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Down etherswitch port 1 Down - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Down etherswitch port 2 Down - - SYS NAME
04/30/2009 | 08:59:02 | 172.16.10.202 | (G) Link Up - - SYS NAME
04/30/2009 | 08:59:17 | Local | (i)Trap Watcher Stopped - closed UDP port 162.
Содержание SpectraComm IP T1
Страница 119: ......
Страница 120: ...The Best Connections in the Business...