General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 64 / 120

SCIP Configuration Configuring Typical SCIP Networks
3-18 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
2. Type
show t1
to check your T1 value entries. Modify, if needed.
3. Type
show config
to display the current configuration of the SCIP. This concludes the
required configurations for a typical flat T1 (LAN-X) network. Test your example network by
pinging from your PC/workstation at the central site to equipment at the remote office, and
vice-versa.
Note
If your application requires the management of terminal server devices, refer to the Terminal Server
Management procedures later in this chapter.
Figure 3-4
SCIP LAN-Extension in a Flat T1 Network (No Routing)
Note
To configure the SCIP with additional features, refer to Chapter 5, Additional Features .
HOST
HOST HOST
LAN
NETWORK
MANAGER
TYPICAL REMOTE OFFICE LAN
ETHERNET0
CENTRAL SITE LAN
T1
HOST
HOST HOST
SERIAL0
LAN
General
DataComm
SCIP-T1
General
DataComm
SCIP-T1
(LAN-X)
T1 INTERNAL TIMING
ETHERNET0
SERIAL0
T1 LINE TIMING
DEVICE 2
DEVICE 1
DEVICE 8
.
.
.
MANAGED
CRAFT DEVICES
TERM1
TERM2
TERM8
.
.
.
MANAGEMENT
ADDRESS
172.16.5.6/16
INBAND
MANAGEMENT
ADDRESS
172.16.5.10/16
172.16.0.0/16
172.16.0.0/16