General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 77 / 120

Additional Features Authentication Protocol
076R200-000 SpectraComm IP T1 Router Card 5-3
Issue 13 Installation and Operation Manual
Server Configuration
Consult your server documentation to configure the server. To function properly with
the SCIP devices in the network, your server must satisfy the requirements listed below:
• The key configured on the server must match the key configured on the SCIP.
• At least one account must be set up.
• If authentication for Supervisor/Admin privilege is desired, use the default
accounts on your server:
$gdc_scip_admin$
(for admin privilege)
$gdc_scip_supervisor$
(for supervisor privilege)
For user-defined accounts, use the following syntax:
[name]
Client (SCIP) Configuration Procedure
Perform all of the steps in the following configuration and verification procedures. Be sure to read
the special considerations for using authentication, listed at the end of this section.
Note
You must log in with ADMIN privileges to execute the commands in this procedure.
1. At the prompt, type:
enable
2. Type your ADMIN password, then press
Enter
.
3. Configure client on the SCIP by typing the following CLI commands. Actual
values shown are SCIP defaults. Per-server key and per-server timeout entries are optional.
configure server add
[server IP address] [per-server key] [per-server timeout]
configure key
[ default key]
configure attempts
[3]
configure timeout
[5]
configure authen enable
Note
authentication is now enabled for user login via Telnet or HTTP (web) only.
4. If desired, enable authentication for console (craft) login by typing:
configure console enable
5. If authentication for Supervisor/Admin privilege is desired, use the default
accounts on your client (SCIP):
$gdc_scip_admin$
(for admin privilege)
$gdc_scip_supervisor$
(for supervisor privilege)