General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 56 / 120

SCIP Configuration Configuring Typical SCIP Networks
3-10 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
Note
Type
show interfaces
to check your interface entries. Modify, if needed.
12. Map Frame Relay DLCIs, IP Encapsulation to sub-interfaces by typing:
configure frame-relay interface-dlci serial0.
[##] [##] [ietf]
For example:
configure frame-relay interface-dlci serial0.17 17 ietf
13. Configure Traffic Shaping per sub-interface by typing the CIR, Bc and Be values. The values
you enter must be consistent with how your Frame Relay network has been configured. Type:
configure frame-relay traffic-shape serial0.
[##] [###### ###### ######]
14. Enable Traffic Shaping by typing:
configure frame-relay ena-traffic serial0.
[##]
15. Set up static routes for the Frame Relay network by typing:
configure ip-route add serial0.17
[destination IP] [destination mask]
[next hop/gateway] [metric]
Note
Steps 16 through 20 detail the setting up of static routes in an example Frame Relay network ( Figure 3-2 ). If
a local router is used at the central site instead of a SCIP-T1 device, consult your router documentation for
static route configuration guidelines.
16. Set up a static route at the remote site towards the central office by typing:
configure ip-route add serial0.17 128.1.0.0 255.255.0.0 128.1.1.10 1
17. On the central office SCIP-T1, create, configure and enable the subinterface by typing:
configure interfaces add-sub serial0.117
configure interfaces enable serial0.117
18. On the central office SCIP-T1, map Frame Relay DLCIs, IP Encapsulation to sub-interfaces by
typing:
configure frame-relay interface-dlci serial0.117 17 ietf
19. Set up a static route at a central office SCIP-T1 towards a remote “orlando_lan” 172.16.0.0 by typing:
configure ip-route add serial0.117 172.16.0.0 255.255.0.0 172.16.5.6 1
As an alternative, to set up a static route only to a particular host instead of to the whole
network, set up the static route with mask 255.255.255.255. For example, to set up LAN
Device #1 on 172.16.0.0 network with an IP address of 172.16.5.10, type:
configure ip-route add serial0.117 172.16.5.10 255.255.255.255 172.16.5.6 1
20. Set up a static route at the central office towards LAN Device #1 connected at the Terminal
Server port by typing:
configure ip-route add serial0.117 192.160.1.12 255.255.255.255 172.16.5.6 1
Note
When setting up static routes, type the short-cut conf ip a ? to get a list of all required arguments.
21. Type
show config
to display the current configuration of the SCIP-T1.