General DataComm SpectraComm IP T1, Руководство по установке и эксплуатации

Страница: 66 / 120

SCIP Configuration Terminal Server Management
3-20 SpectraComm IP T1 Router Card 076R200-000
Installation and Operation Manual Issue 13
CLI Command Access
This procedure allows authorized users password-protected access to enabled terminal server ports
using the SCIP’s command line interface. Using CLI, you do not need to disconnect a Telnet session
to manage multiple terminal server devices.
1. Make a craft connection to the SCIP, or start a Telnet session at the DOS prompt by typing:
telnet
[SCIP IP address]
2. Login to the SCIP with a valid username and password. If necessary, override any other Telnet
CLI session in progress as instructed by the screen prompt.
3. If needed, review the status of any attached terminal devices, as shown in the example below.
Press the spacebar to view the lower portion of the display.
4. To manage a specific terminal server device, type:
connect term
[#]
5. With a successful connection, the following prompt appears.
MasterSCES-18> ^^
Remote SC-IP> connect term8
Connecting to term8 (SCES)
Use "^^^" as escape sequence
6. Press the Enter key to access the management interface of this terminal server device.
7. When complete, press the escape sequence
^^^
to return to the SCIP CLI.
Remote SC-IP> show term-serv
_____________________________Terminal Status__________________________________
Terminal Telnet SSH Admin
Name IP Address Port Port State Attributes Comms
----------- --------------- ------ ---- ----- ---------- ----------
term1 ---.---.---.--- 2001 3001 ON Idle 9600 8N1
term2 ---.---.---.--- 2002 3002 ON Idle 9600 8N1
term3 ---.---.---.--- 2003 3003 ON Idle 9600 8N1
term4 ---.---.---.--- 2004 3004 ON Idle 9600 8N1
term5 ---.---.---.--- 2005 3005 ON Idle 9600 8N1
term6 ---.---.---.--- 2006 3006 ON Idle 9600 8N1
term7 ---.---.---.--- 2007 3007 ON Idle 9600 8N1
term8 ---.---.---.--- 2008 3008 ON Idle 9600 8N1
Escape sequence for connect: "^^^"
To connect to a terminal, use "connect" command from shell.
Or use SSH/TELNET with ethernet0 IP address and indicated port number.
Or use SSH/TELNET with dedicated Terminal IP address and standard port.
TELNET Menu for Terminal Server is enabled.
SSH Menu for Terminal Server is enabled.
Terminal Descriptions
------------------------------------------------------------------------------
term1 MetroPlex 6000
term2 SCM
term3 DeskTop554A
term4 modem
term5 Old Host Modem
term6 New Host Modem
term7 innovx553 or SC553
term8 SCES