Fuji Xerox DocuPrint 5105 d, Руководство пользователя

Страница: 148 / 419

148
5 Control Panel Settings
Setting Description
IP Mode
Sets the IP mode.
• [IPv6]
The IPv6 mode is used. Advanced settings are unnecessary since it is
automatically configured.
• [IPv4]
The IPv4 mode is used. Set the IP address from [IPv4 Settings].
• [Dual Stack] (default)
Both the IPv4 and IPv6 modes can be used.
IPv4
Settings - Sets the IPv4 settings
Note
• When the Secondary Ethernet Kit (optional) is installed, [IPv4 Settings 1]
and [IPv4 Settings 2] are displayed.
Get IP
Address Sets the method of obtaining the information (IP address, subnet mask, or
gateway address) required to use the TCP/IP protocol.
• [DHCP / AutoIP]
(default)
Automatically obtains information from a DHCP (Dynamic Host
Configuration Protocol) server that has the AutoIP feature.
• [STATIC]
Sets the information manually on the control panel. Consult your network
administrator for the IP address.
• [DHCP]
Automatically obtains the information from the DHCP server.
• [BOOTP]
Automatically obtains the information from the BOOTP.
• [RARP]
Automatically obtains the information from the RARP.
Note
• When [DHCP/AutoIP], [DHCP], [BOOTP], and [RARP] is changed to
[STATIC], a screen for setting the IP address is sometimes displayed.
Manually set the IP address when this screen is displayed.
IPv4
Settings IP Address,
Subnet Mask,
Gateway
Address Allows you to verify the automatically acquired IP address or manually
enter the IP address.
Enter the IP address in the format xxx.xxx.xxx.xxx. Any number from 0 to
255 can be set for each xxx in the IP and gateway addresses. However, the
initial xxx cannot be 127 or any number from 224 to 255. For subnet masks,
each xxx must be one of the following numbers: 0, 128, 192, 224, 240, 248,
252, 254, and 255. (See *2 on P. 215.)
Important
• Make sure that you set the IP address correctly. Setting the wrong
address can cause problems on the network.
• If the correct address is not entered in the subnet mask (e.g. 0 is set in
bits midway), the previous setting is restored to even if you press the
<Settings> button after the number is set. You cannot configure other
items until the correct value is set.
• Set the gateway address only when it must be clearly indicated. This
setting is not required in environments where the gateway address is
automatically set.
Ping
Connect Test IP Address
(IPv4)
Allows you to confirm whether the machine connects your computer
properly or not with the configured condition. Enter the IPv4 address of
your computer to start testing.
Note
• When the Secondary Ethernet Kit (optional) is installed, [IP Addr. (IPv4)
1] and [IP Addr. (IPv4) 2] are displayed.