Fuji Xerox DocuPrint 5105 d, Руководство пользователя

Страница: 60 / 419

60
2 Basic Operation
2.4 Setting/Exiting the Power Saver Modes
The printer has Power Saver modes that reduce electric power consumption while the printer is
in stand-by. There are two Power Saver modes: a Low Power mode (59W or less (AC110-120V),
61W or less (AC220-240V)) and a Sleep mode (2W or less).
The sleep mode completely turns off all power except for the controller
’
s receiver to minimize
power consumption. Note that the warm up time required to recover from sleep mode is longer
than that of during Low Power mode.
The Low Power mode does not turn off power completely, but it strikes a balance between power
consumption and warm up time by keeping temperature of the fusing unit between full and
Sleep mode.
Entering the Power Saver Modes
The initial factory default settings for both the Low Power mode/Sleep mode trigger times are [1
Minutes Later], so the printer will go directly into Sleep mode without going into the low power
mode whenever no print data is received by the printer for one minute.
Whether to trigger Low Power/Sleep mode can be set for this printer, and the Low Power/Sleep
mode trigger time can be set within a range of 1 to 240 minutes.
Important
• The life of the fusing unit is largely influenced by power distribution time on the printer. If you set the printer’s
stand-by period longer before entering to the Power Saver Modes, the power distribution time gets longer as well.
It may cause an early replacement of the fusing unit of the printer. For more information, contact our Customer
Support Center.
Note
• The printer can be configured to use just the Low Power mode or Sleep mode.
• Both Low Power mode and Sleep mode triggering cannot be disabled at the same time.
• For information about configuring Low Power mode and Sleep mode settings, refer to "Setting Example: Changing
the Sleep Mode Timer" (P. 145).
Exiting the Power Saver Modes
The printer automatically exits the Power Saver modes when it receives a print job from a
computer. If IC Card Reader (optional or purchase separately) is connected to the printer, you
can exit Low Power mode by touching a smart card during Low Power mode. However, exiting
Sleep mode is not available.
To exit the Power Saver mode manually, press the <Power Saver> button on the control panel.
Note
• The IC Card Reader may not be supplied with the printer in some regions. Contact your dealer for details.
If the Printer Does Not Enter Power Saver Mode
The printer does not enter Low Power mode or Sleep mode in the following cases to inform users
on what is happening to the printer and provide its performance.
• When the user is operating the control panel
• When a message indicating to replace any items such as consumables (toner cartridge or
drum cartridge) is displayed
• When the printer requires user operation for paper jams or open covers
• When an error occurs due to print failure