Fuji Xerox apeosport-iv C3370, Руководство администратора

Страница: 165 / 889

Common Service Settings
165
T
ools
5
5
Select [Save].
NTP Time Synchronization
You can synchronize the machine clock with a time server (NTP: Network Time Protocol),
receiving time information from the server.
To connect to a time server, select [On] for [NTP Time Synchronization], and set the IP
address of the time server in [Time Server Address].
Connection Interval
Select the time interval to connect to the time server.
You can select from 1 to 500 hours in 1 hour increments.
Time Server Address
Set the server name or IP address of the time server.
Note
z
For IPv4, enter the IP address in xxx.xxx.xxx.xxx format, where "xxx" is a value between 0 and 255.
z
For IPv6, enter the IP address in xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format, where "xxxx" is a hexadecimal
number.
Auto Clear
Specify the time lapsed without any operation until the machine resets the settings
automatically.
When you select [On], specify a value between 10 and 900 seconds in 1 second increments.
When you select [Off], the settings are not reset automatically.
Note
z When [Off] is selected, the machine will cancel the standby status and begin processing a document after
one minute has elapsed in anticipation of a job command.
z
The timer does not start counting until the operator leaves the detectable area of Smart WelcomEyes.
Auto Job Release
Specify the time lapsed until the machine cancels the active job and starts the next job if
an error such as document or paper jams and running out of paper occurs during copying or
scanning. In that case, only those jobs not affected by the error can be processed.
When you select [On], specify a value in 1 minute increments. When you select [Off], the
active job is not canceled automatically.
Note
z
The timer does not start counting until the operator leaves the detectable area of Smart WelcomEyes.