Fuji Xerox apeosport-iv C3370, Руководство администратора

Страница: 416 / 889

Scanner Environment Settings
416
Sc
a
n
n
e
r Enviro
n
ment
Settings
9
4
Set an IP address and the other addresses.
Skip this step if an IP address is already set.If DHCP or BOOTP is available in your
environment, configure the method for obtaining the addresses. If an IP address cannot be
obtained automatically or manual configuration is preferred, confirm the settings of an IP
address, a subnet mask, and a gateway address.
Note
z
For information on how to set an IP address, refer to "Protocol Settings" (P.239).
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
Note
z Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
7
Print a configuration report to confirm that the SOAP, SNMP, and Internet Services (HTTP)
ports are enabled and that TCP/IP is set up correctly.
Reference
z For information on how to print a configuration report, refer to "Print Reports" (P.131).
Step 2 Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1
Start CentreWare Internet Services.
Reference
z For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.368).
2
Configure the transport protocol for the SNMP port.
1) Click the [Properties] tab.
2) Click [Connectivity].
3) Click [Port Settings].
4) Select the [UDP] check box under [SNMP].
5) Click [Apply].
6) The right frame of the web browser changes to the machine reboot display.
7) Click [Reboot Machine]. The machine reboots and the settings are enabled.
Step 3 Configuration on the Computer
Create job flows using Device Setup Tool to use for scanned documents.
Note
z
Device Setup Tool is included in ApeosWare Management Suite, which you can download from our web site.