Fluke OF-500 OptiFiber, Техническое справочное руководство

Страница: 54 / 282

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
2-8
Viewing Test Limits
To see the values of a test limit that includes the fiber
type selected on the
Cable tab, do the following:
1 Press
S
; then select a test’s tab.
2 Select TEST LIMIT .
3 Highlight a limit on the SET TEST LIMIT screen; then
press
A
View Limit.
If the Test Limit or Fiber Type is Not Valid with the
Test
•
The fiber type was changed on the Cable tab in
Setup, and the current test limit does not include the
fiber type. Select a different test limit.
•
The fiber type or test limit is missing a wavelength
the test uses. For example, you are trying to run a
dual-wavelength OTDR test, but the fiber type or
limit does not include both wavelengths. Select a
different fiber type or test limit.
•
The installed module does not support the selected
fiber type or test limit. For example, a singlemode
fiber type is selected, but a multimode module is
installed. Select a different fiber type or test limit or
install a different module.
•
The test limit does not include parameters for the
type of test you are trying to run. For example, you
are trying to run an OTDR test, but only loss/length
limits are defined in the selected test limit. Select a
test limit that includes limits for the test you want to
run.
If you selected a custom fiber type or limit, you could also
edit the fiber type or limit to make it valid with the test.
See Chapter 10 for details.
Entering Job Settings
Job settings let you identify and organize the test results
you save. To access the job settings press
S
. Table 2-2
describes the job settings.
See “Tutorial: Preparing to Save Tests” on page 2-11 for
examples of how to configure the job settings.