Fluke 5502A, Руководство оператора

Страница: 20 / 378

5502A
Operators Manual
1-4
waves to 2 MHz.
•
A Standard IEEE-488 (GPIB) interface that complies with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
•
A EIA Standard RS-232 serial data interface to print, show, or move internally stored
calibration constants, and for remote control of the 5502A.
•
A pass-through RS-232 serial data interface to send data to the Unit Under Test
(UUT).
Safety Information
In this manual, A
Warning
identifies condition s and procedures that are dangerous to the
user. A
Caution
identifies conditions and procedures that can cause damage to the
Product or the equipment under test.

Warning
To prevent possible electrical shock, fire, or personal injury:
•
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
•
Carefully read all instructions.
•
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
•
Use this Product indoors only.
•
Do not touch voltages > 30 V ac rms, 42 V ac peak, or
60 V dc.
•
Do not use the Product if it operates incorrectly.
•
Do not use and disable the Product if it is damaged.
•
Do not use test leads if they are damaged. Examine the test
leads for damaged insulation, exposed metal, or if the wear
indicator shows. Check test lead continuity.
•
Use only cables with correct voltage ratings.
•
Connect the common test lead before the live test lead and
remove the live test lead before the common test lead.
•
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.