5.0 SYSTEM DIAGNOSTICS
UL S2203
CyberCat 254/1016 Operation Manual
5-23
FM
P/N: 06-326-2
Rev 6, 09/2015
•
Row D – Displays a description of the status numbers indicated in Row C. The numbers align
with the following voice status conditions:
0
= Panel automatic conditions are active (see below).
“AUTO-NONE”
(no automatic voice condition is active)
“AUTO-PROC”
(automatic process condition is active)
“AUTO-SUPV”
(automatic supervisory condition is active)
“AUTO-TEST”
(walk-test condition is active)
“AUTO-ALRM”
(automatic alarm condition is active)
“AUTO-ALRT”
(automatic alert condition is active)
“AUTO-EVAC”
(automatic evacuate condition is active)
2
=
“DRILL”
(drill condition is active)
3
=
“ALERT”
(alert condition is active)
4
=
“EVACUATE”
(evacuate condition is active)
5
=
“PAGE”
(page condition is active)
6
=
“PAGE W RR”
(page with record and repeat condition is active)
7
=
“FIRE MSG”
(fire alarm messaging condition is active)
8
=
“MNS PAGE”
(mass notify paging condition is active)
9
=
“MNS W RR”
(mass notify paging with record and repeat condition is active)
10
=
“MNS MESSG”
(mass notify messaging condition is active)
Note:
Previous is the level that was active in the zone before the current level became active.
When the current level clears, the previous level will be returned as the current priority level.
5.7.4
PERIPHERAL FIRMWARE VERSION
The Peripheral Firmware Version screen allows you to view the firmware version of the selected peripheral
bus device. From the Diagnostic Menu 4 screen, press the F4 button to view the Firmware Version screen:
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
A
P E R I P H E R A L A D D R : 0 2
B
T Y P E : D I G I T A L P A G I N G
C
F I R M W A R E V E R S I O N
D
X X . X X
Exhibit 5-31: Firmware Version Screen
•
Row A - Allows you to select the address of the peripheral device (1 – 32) that will be displayed in
Rows C and D. Use the +/- buttons to increment or decrement the peripheral address.
•
Row B – Displays the type of peripheral device currently configured at the peripheral address
selected in Row A.
Available Peripheral Devices:
Rem Disp 14Key
Print+Gateway (MIM)*
Switch 20-Zone
Digital Paging
256 LED Graphic
Gateway Only (MIM)*
Annunc 20-Zone
Relay Control
Zone Graphic
Ethernet Port
Computer
Class A Module
Print Serial (MIM)
Rem Disp 10Key
Amplifier
Remote MIC
Bosch DACT
Rem Disp 2 Key
Fire-Phone Int
Print Parallel (MIM)
Smoke Control
6Z Voice EVAC
•
Row C – Displays “FIRMWARE VERSION” unless the selected device is an amplifier card; then
this row will display “DS PIC” and its firmware version.
•
Row D – Displays “FIRMWARE VERSION” unless the selected device is an amplifier card; then
this row will display “NAC PIC” and its firmware version.
* Gateway Only and Print+Gateway is not available in V7.00 firmware and higher.
