EZ-GO ST 4X4, Руководство по ремонту и обслуживанию техника

Страница: 161 / 184

P
Page P-1
4GRCKTCPF5GTXKEG/CPWCN
4GCFCNNQH5GEVKQP$CPFVJKUUGEVKQPDGHQTGCVVGORVKPICP[RTQEGFWTG2C[RCTVKEWNCTCVVGPVKQPVQCNN0QVGU%CWVKQPUCPF9CTPKPIU
'0)+0'
For engine troubleshooting, diagnostic and repair
procedures, refer to Honda Engines Owner’s Manual 6 X
610 shipped with vehicle or 4 X 610 / 620 Engine Shop
Manual.
)#51.+0'8'*+%.'2'4(14/#0%'
Condition Possible Cause Correction
STARTER DOES NOT TURN Weak or bad battery Recharge or replace as necessary
Terminals are loose or corroded Clean and retighten
Poor wiring connections Repair or replace wire and/or connections
Faulty Ignition Switch Repair or replace wire and/or connections
Solenoid faulty If no audible ‘click’ is heard, check power and
ground. Replace solenoid if power
and ground is good
Starter terminals are loose or corroded Tighten or clean
Leads are broken or faulty ground Check for breaks at bend or joint.
Replace or repair leads
Field coils are open Repair or replace
Armature coil is open Repair or replace
STARTER TURNS SLOWLY Terminals are loose or corroded Retighten or clean
Weak battery Charge battery
Crankcase over filled with oil Drain and fill to recommended level with ap-
proved oil
Leads are nearly broken or connections
are faulty Check for any defect of leads at bend or joint.
Replace leads or repair connections
Mechanical problem inside
starter Check
Internal engine damage Inspect and repair
Crankcase over filled with oil
TROUBLESHOOTING