EZ-GO ST 4X4, Руководство по ремонту и обслуживанию техника

Страница: 110 / 184

ENGINE AND TRANSMISSION
Page H-16
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
Remove the seat bottom (Ref Seat Bottom Replacement
section in BODY AND TRUCK BED). Remove seat back
assembly and seat crossmember (Ref Seat Back
Replacement section in BODY AND TRUCK BED).
Remove the engine (Ref ENGINE REMOVAL/INSTAL-
LATION section on page H-7). Remove the transmission
(Ref TRANSMISSION REPLACEMENT section on page
H-13).
Hold the bolts (item 1) using 9/16" socket and remove the
nuts (item 2) using 9/16" wrench (Ref Fig. 24 on page H-
16). Remove the washer (item 3) and remove the engine
subframe (item 4).
Installation of the engine sub frame is the reverse of dis-
assembly using new lock nuts.
Tighten the hardware per torque specification table given
below.
ISOLATION MOUNT REPLACEMENT
Tool List Qty. Required
Ratchet, 3/8" drive .......................................................1
Torque wrench, 3/8" drive, ft. lbs ................................. 1
Socket, 1/2" ................................................................. 1
Wrench, 1/2" ................................................................ 1
Before starting, refer SAFETY section. Park the vehicle
on a level surface, engage park brake. Disconnect nega-
tive (-) cable from the battery to prevent electrical shorts.
Release the handle and raise the truck bed. Remove the
gas spring (Ref Gas Spring Replacement section in
BODY AND TRUCK BED).
Fig. 24 Engine Sub frame Replacement
4
1
3
2
ITEM NO TORQUE SPECIFICATION
2 20 - 25 ft. lbs (27 - 34 Nm)