EZ-GO ST 4X4, Руководство по ремонту и обслуживанию техника

Страница: 145 / 184

REAR AXLE AND SUSPENSION
Page M-3
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
Tighten the hardware per torque specification table
below.
Rear Drive Shaft Removal
Use a commercially available Anti-Seize com-
pound on Shaft and Bearing splines.
Tool List Qty. Required
Wheel chocks.............................................................. 4
Torque wrench, 1/2" drive, ft. lbs ................................. 1
Impact wrench, 1/2" drive............................................ 1
Impact Socket, 1/2", 1/2" drive .................................... 1
Ball peen hammer ....................................................... 1
Park the vehicle on a flat surface. Engage park brake.
Install chocks in front and behind each rear wheel.
Release truck bed handle and lift the bed. The rear drive
shaft (item 3) can be accessed from the top. Remove
bolts (item 1) and washers (item 2) using 1/2" impact
socket (Ref Fig. 4 on page M-3). Compress rear drive
shaft (item 3) and remove it.
The installation of the rear drive shaft is the reverse of
disassembly. Use new locking bolts.
Tighten the hardware per torque specification table
below.
Rear Differential Guard Replacement
Tool List Qty. Required
Open end wrench, 9/16".............................................. 1
Torx bit screwdriver T- 45 ............................................ 1
Fig. 3 Solenoid Replacement
ITEM NO TORQUE SPECIFICATIONS
2 4- 6 ft. lbs (5 - 8 Nm)
1
3
2
6
4
7 8
5
Front of the Vehicle
Fig. 4 Rear Drive Shaft Removal
ITEM NO TORQUE SPECIFICATIONS
1 21 - 25 ft. lbs (24 - 34 Nm)
Fig. 5 Rear Differential Guard Replacement
1
2
3
Front of the Vehicle
3
2
1