Plasma
Generation
PlasmaQuant MS Series
74
Figure 6-16 - Parts required for plasma coil alignment
2.
Check that the left edge of the torch holder is parallel with the right edge of the
PEEK frame that holds the work coils (see Figure 6-16).
3.
A little gap must be visible on the top edge of the torch holder when the clamp is
open (Figure 6-17).
4.
Open the torch holder.
Figure 6-17 - Visible gap behind torch holder
5.
Loosen screw (Figure 6-18) and move slider into the middle position, then re-
tighten the screw.