ELTRA CS-2000, Руководство по обслуживанию

Страница: 81 / 160

Adjustments
81
Outputs (base lines about 8VDC)
TP 22: Output section [1]
TP 25: Output section [2]
TP 24: Output section [3]
TP 23: Output section [4]
TP 20: Analog GND
NOTICE
Use a very thin screwdriver. With a big screwdriver, the trimmer can be mechanically destroyed
before you feel it. The screwdriver should never get in touch with the hole resp. the housing of
the preamp, otherwise the trimmer may be mechanically stressed and break.
4.2.6 Voltage of a base line is too high (higher than 9.5V)
The optimal value for the base lines of the IR-paths is about 8V. Golden paths have the effect to
become more reflective in the first few months of their operation. To compensate this effect, the
original value of the golden paths base line should be adjusted at 5 V. In case of a long golden
paths (300mm) having sensors including on-chip preamplifier, the cell output sometimes cannot
be adjusted down to the required 5 to 6V by turning counter clockwise the trimmer in the
preamplifier. (Outputs: TP22 to TP25 against AGND = TP20).
In this case the IR sources voltage has to be reduced until you get a base line of the troubled
golden cell down to about 5 to 6V. You will then need to increase the gain of the other cells
preamps to get their base lines back to the range of 8V.
Source voltage
– reducing
1. Take the IR cell out of the analyser.
2. Power the cell by an external 24VDC power supply connected to J1 of the IRC board.
3. If the external power supply cannot supply 5A then set a jumper on position 2 (Test °C) of
JP1 in order to switch off the temperature control so that a power supply of 1A is
adequate. If a jumper is available on position 3 or 4 (Analysis), this jumper can be moved
to position 2. The positions 3 and 4 are simply parking positions for jumpers to simply be
available when needed. There are no tracks connected on the pins of the (Analysis)
positions 3 and 4 of JP1.
4. Make sure that the gain of the preamplifier in question is adjusted to a minimum
gain. To do this, turn its trimmer counter clockwise up to the end of trimmer range.
These trimmers have a maximum of 20 turns. When the end of range has been reached,
you can hear a gently silent click with each turn.
It is not possible to feel any
mechanical resistance on the screw driver.
5. Measure the actual source voltage between on TP7 against GND=TP1 and note the
value.
6. Turn the potentiometer R80 of the IRC board counter clockwise up to the end of its range.
(Maximum gear range = 20 turns).
7. Switch off resp. disconnect the power supply.
8. Move the jumper of JP2 to position 5.
9. Connect the 24V power again.
10. Connect the multimeter to the cell output which has to be adjusted.
11. Wait for the sources to warm up until the output voltage will almost reach its maximum
value.
12. Turn the trimmer R80 slowly clockwise until the base line of the cell in question has
reached 8V. In case of a clean golden path, adjust between 5V and 6V instead of 8V.