Eddyfi Technologies Floormap X, Руководство пользователя

Страница: 96 / 106

SIMS PRO
96
IMPORTANT
The EPL value for selected bottom indications become adjusted based upon the top surface
calibration trace.
NOTE
If the view is set to Bottom the indications are no longer shown on the plate, but the
indication selection box outlines remain visible since they are still selected.
Bottom
Click Bottom on the indication ribbon to set the surface origin of the selected indications to become
bottom and set the status to accepted.
IMPORTANT
The EPL value for selected top and both indications become adjusted based upon the bottom
surface calibration trace.
NOTE
If the view is set to Top the indications are no longer shown on the plate, but the indication
selection box outlines remain visible since they are still selected.
Both
Click Both on the indication ribbon to set the surface origin of the selected indications to become
both and set the status to accepted.
IMPORTANT
The EPL value for selected bottom indications become adjusted based upon the top surface
calibration trace.
Reset Indication Modification
Click Reset Indication Modification on the indication ribbon to revert the selected indications back
to their initial imported status and EPL values.
5.13 Modification Ribbon
The modification ribbon is a hidden ribbon and only available when in plate view and the enable plate
modification, in plate properties, is ticked. This ribbon provides the ability to correct plate setup errors
made during data acquisition.
Figure 131: Modification ribbon
Enable Plate Modification
To perform plate modifications, such as correcting plate setup errors made during data acquisition
or repositioning of scan then enable plate modification must be selected in plate view. To select:
1. In plate view select the plate.
2. In the properties tick Enable Plate Modifications .
3. Read the information box then click OK .