Eddyfi Technologies Floormap X, Руководство пользователя

Страница: 100 / 106

Troubleshooting and Maintenance
100
controlled and is within the allowable limits for air shipment.
Each component of the FloormapX system must be correctly packed into the correct transit case.
Refer to the supplied packing lists.
If the FloormapX system is to be shipped elsewhere, the original packaging and transport protection
inserts
MUST be used.
Packing the FloormapX scanning head
Before packing the FloormapX scanning head, first it must be disassembled from the system. To
disassemble and pack:
1. Ensure the magnets are turned off.
2. Power down the system.
3. Remove the battery from the active slot on the mainframe, and place into the mainframe transit
case and replace the battery panel.
REMOVE BATTERY
When the FloormapX system is powered off the battery must be removed from the right-
hand active battery slot and placed into the left-hand storage slot. The battery capacity has
a potential of discharging if left in the active slot when the system is not powered on.
4. Remove the motorization and sensor cables between the mainframe and scanner head. Place
these into the mainframe case.
5. Whilst supporting the mainframe and stopping the scanner head from rolling, unscrew and
remove the two brass rear attach bolts located at the rear of the scanning head.
6. Lay the mainframe down on the floor, so that it rests on its back. The mainframe and scanning
head are now free of each other.
7. Replace the brass rear attach bolts into the scanner head rear attach mechanism, screwing
them fully in, so that they do not rattle loose in transit.
8. Lift the scanner head by the front handle so that it rests on its back on the rear attach
mechanism.
9. Lift the scanner head by the front handle into the case so that the rear wheels contact the foam.
NOTE
The scanner head will only fit on one orientation into the transit case.
10. Holding the front handle roll the scanner head back into the foam and lower the front end down
till it is flat.
Figure 132: Scanner head transit case packing
11. Close the lid of the transit case and engage the transit case clasps.