Eddyfi Technologies Floormap X, Руководство пользователя

Страница: 32 / 106

FloormapX System Overview
32
12. Attach the tablet connector from the mainframe to the scanner connector on the tablet.
Figure 22: FloormapX tablet connector
13. Remove the battery compartment cover and fit a battery into the right-hand active battery slot.
If required insert a spare fully charged battery into the left-hand slot. Replace the battery
compartment cover.
Figure 23: FloormapX battery compartment
14. Power the system on by pressing the tablet power button or the user control power button.
15. The system is ready to use once the software has loaded and the system has completed is power
on sequence of flashing headlights.
REMOVE BATTERY
When the FloormapX system is powered off the battery must be removed from the right-
hand active battery slot and placed into the left-hand storage slot. The battery capacity has
a potential of discharging if left in the active slot when the system is not powered on.
2.4 Recommended Scanning Bridge Height
To account for varying levels of imparted magnetism the following table contains recommended
operating conditions when performing a calibration and subsequent inspection. The low setting will
provide the best detection capability. The high setting can be used on thinner plates or to provide
better ground clearance.
Metric
Coating Thickness (mm)
0mm 1mm 2mm 3mm 4mm 5mm 6mm
Pl
at
e
Thi
ckne
ss
(m
m
)
6mm High or Low High or Low High or Low High or Low Low Low Low
8mm High or Low High or Low High or Low Low Low Low Low
10mm High or Low Low Low Low Low Low Low
12mm Low Low Low Low Low Low Low
14mm+ Low Low Low Low Low Low Low