Eddyfi Technologies Floormap X, Руководство пользователя

Страница: 29 / 106

FloormapX System Overview
29
Fitting a FloormapX Battery
To fit a battery in the FloormapX:
1. Remove the battery cover by unscrewing the two thumbscrews.
2. Insert battery into the right-hand active battery slot with the battery connector.
3. Turn battery locking cam clockwise at the top of the battery to secure the battery in position.
4. Reattach the battery cover.
WARNING
A battery that is incorrectly fitted, connected and / or secured can result in serious harm to
the operator and FloormapX.
IMPORTANT
It is important that the FloormapX is operated with the battery correctly fitted, secured and
with the battery cover always fitted. Failure to do so will invalidate the warranty.
Removing a FloormapX Battery
To remove a battery from the FloormapX:
1. Power off the system by press and hold the power button for 2 seconds then selecting Turn off.
2. Remove the battery front cover by unscrewing the two thumbscrews.
3. Release the battery locking cam by turning counter clockwise.
4. Using the carry handle, remove battery from the FloormapX.
Charging a FloormapX Battery
The FloormapX is supplied with 2 battery chargers. A flat battery typically requires approximately 6-
7 hours of charge time. When charging the battery has a charging voltage of 36VDC and a maximum
charge current of 1.5A.
WARNING
Use of any other charger unit will invalidate the warranty and may result in battery
malfunction, damage and or may result in fire.
Figure 19: FloormapX battery charger information
To charge a battery:
1. Remove the battery from the FloormapX.
2. Correctly connect the charger cable to the FloormapX battery.
3. Begin the charge process by connect the battery charger to a suitable mains power supply and
power on. During the charging process check the LED indicator on the charger to determine the
charging mode.
IMPORTANT
If the charger LED displays an error, please power off the charger.