![background image](http://html1.mh-extra.com/html/eaton/elcm-series/elcm-series_operation-manual_4035918292.webp)
E L C O p e r a t i o n M a n u a l
F o r m o r e i nf o r m a t i o n v i sit :
w w w. e a t o n . c o m
MN05003006E
4-8
4.1.1.7 Installation and Wiring
1. Installation the DIN rail
y
The ELC can be secured to a cabinet by using DIN rail that is 35mm high with a depth of
7.5mm. When mounting the ELC on the DIN rail, be sure to use the end bracket to stop
any side-to-side motion of the ELC. At the bottom of the ELC is a small retaining clip. To
secure the ELC to the DIN rail, place it onto the rail and push up on the clip.
y
When installing the ELC, make sure that it is installed in an enclosure with sufficient
space around it for proper heat dissipation, as shown below.
2. Wiring
y
It is recommended that 22-16 AWG (1.5mm) single-core bare wire or multi-core wire is
used for the I/O wiring. The specification for the terminal is shown in the figure below on
the left side. The ELC terminal screws should be tightened to 1.95 kg-cm (1.7 in-lbs) and
use 60/75°C copper conductor only.
y
I/O signal wires and the power supply wires should not run through the same multi-wire
cable or conduit.
22-16AWG
< 1.5mm
Содержание ELCM Series
Страница 1: ......
Страница 107: ...ELC Operation Manual For more information visit www eaton com MN05003006E 2 20 MEMO...