![background image](http://html1.mh-extra.com/html/eaton/elcm-series/elcm-series_operation-manual_4035918130.webp)
3. AIAO Units
MN05003006E F or more information visit:
w w w. e a t o n . c o m
1-23
C R # 2 8 , 2 9 :
Adjusted GAIN value of CH1 ~ CH2
1. The adjusted GAIN value for CH1 ~ CH2 on the ELC-AN02NANN, representing the
analog output voltage or current when the digital output value is 2,000. Default = K2,000.
Unit: LSB.
2. The adjustable range of voltage: -4V ~ +20V (0
LSB
~ +4,000
LSB
).
3. The adjustable range of current: -8mA ~ +40mA (0
LSB
~ +4,000
LSB
).
4. Please note that: GAIN value – OFFSET value = +400
LSB
~ +6,000
LSB
(voltage or
current). When GAIN – OFFSET is small, the resolution of output signal will be finer and
variation on the digital value will be greater. When GAIN – OFFSET is large, the
resolution of output signal will be grainier and the variation on the digital value will be
smaller.
C R # 3 0 :
Data register for storing all errors
CR#30 is the fault code. Please refer to the following chart.
Fault Description
Content
b15~b8
b7 b6 b5 b4 b3 b2 b1 b0
Power
Source
Abnormal
K1(H1)
0
0 0 0 0 0
0
1
Analog output Value Error
K2(H2)
0
0 0 0 0 0
1
0
Setting
Mode
Error
K4(H4)
0
0 0 0 0 1
0
0
Offset/Gain
Error
K8(H8)
0
0 0 0 1 0
0
0
Hardware
Malfunction
K16(H10)
0
0 0 1 0 0
0
0
Digital
Range
Error
K32(H20)
0
0 1 0 0 0
0
0
Average
Times
Setting
Error K64(H40)
0
1 0 0 0 0
0
0
Command Error
K128(H80)
Reserved
1
0 0 0 0 0
0
0
Note: Each fault code will have corresponding bit (b0~b7). Two or more faults may happen
at the same time. 0 means normal and 1 means having fault.
C R # 3 1 :
RS-485 communication address setting
The settings for the RS-485 communication address. Range: 01 ~ 255. Default = K1. This
setting is only valid for RS-485 communication and will be invalid when connected to an ELC
controller.
C R # 3 2 :
Communication speed (baud rate) setting
The interface settings for the RS-485 communications: data rate: 4,800, 9,600, 19,200,
38,400, 57,600 and 115,200bps (bits per second). Default = H’0002.
b0 = 1:
4,800 bps
b1 = 1:
9,600 bps (default)
b2 = 1:
19,200 bps
Содержание ELCM Series
Страница 1: ......
Страница 107: ...ELC Operation Manual For more information visit www eaton com MN05003006E 2 20 MEMO...