Eaton ELCM Series, Руководство по эксплуатации

Страница: 227 / 336

E L C O p e r a t i o n M a n u a l
F o r m o r e i nf o r m a t i o n v i sit :
w w w. e a t o n . c o m
MN05003006E 1-120
C R # 4 2 :
Function: Return to default settings. Default = H0000
Description
bit0 b0=0, no action on CH1; b0=1, set CH1 to default setting
bit1 b1=0, no action on CH2; b1=1, set CH2 to default setting
bit2 b2=0, no action on CH3; b2=1, set CH3 to default setting
bit3 b3=0, no action on CH4; b3=1, set CH4 to default setting
bit4 B4=0, no action on CH5; b4=1, set CH5 to default setting
bit5 B5=0, no action on CH6; b5=1, set CH6 to default setting
bit6 ~ bit15 Reserved
Note: Set the appropriate bit to 1 and the corresponding channel will be returned to default
settings. When complete, the value will be set to 0. If CR#40 (Prohibit Configuration changes)
is enabled, setting defaults will be invalid, and all configuration values will remain unchanged.
Error Code bit 12 of CR#43 will be set to 1.
Affected Parameters
CR#2 ~ CR#5 Input mode setting of CH1 ~ CH4
CR#6 ~ CR#7 Output mode setting at CH5 ~ CH6
CR#8 ~ CR#11 Sampling range of CH1 ~ CH4
CR#28 ~ CR#33 Adjusted Offset value at CH1 ~ CH6
CR#34 ~ CR#39 Adjusted Gain value at CH1 ~ CH6
CR#100 Function: Enable/Disable limit detection
CR#102~CR#107 Set value of CH1~CH6 upper bound
CR#108~CR#113 Set value of CH1~CH6 lower bound
CR#114~CR#115 Output update time of CH5 ~ CH6
CR#118 LV output mode setting
C R # 4 3 :
Error status. Default=H’0000
CR#43: error status value. See the table below:
Description
bit0 K1 (H’1) Power Supply error
bit1 K2 (H’2) Hardware error
bit2 K4 (H’4) Upper / lower limit error
bit3 K8 (H’8) CH1 Conversion error
bit4 K16 (H’10) CH2 Conversion error
bit5 K32 (H’20) CH3 Conversion error
bit6 K64 (H’40) CH4 Conversion error